When using PoE+, the power provided to the camera is 12V 1A, depending on the network switch.The input voltage will be directly applied to the camera so if you power from batteries, make sure the camera does support the higher battery voltage as well.įor thermal reasons, camera consumption should not exceed 12W by port. Make sure that the cameras connected support the voltage you supply on DC IN. Thus, the input voltage will be present on the 2 camera ports. When powered with the DC IN plug, the voltage is not regulated. When powered with PoE, the output voltage on ports connectors will be 12V DC, regulated. The CI0 can be powered through PoE+ or an external 12V 2A DC power supply.

You can follow this guide to guide you through the setup. As such, IP addresses are fixed based on the serial number, and a discovery process makes the CI0 appear automatically on the RCP interface.ĬI0 relies on TCP/IP network with no port limitation in order to communicate with other devices.īy using a TPLink nano router, you can control your camera over WiFi. The CI0 has been designed to be plug and play and avoid conflicts.

When camera supports Serial BUS, several camera can be connected on a single port (see: CI0 Serial BUS).

Two ports available on base CY-CI0 model, three ports available on CY-CI03P.

Several Serial camera connected to CI0.

Basic configuration where CI0 turns a camera into managed camera.

CY-CI0BM: CI0 two ports with BlackMagic SDI control extension (see: BM serial cam integration manual).ĭifferent CI0 Ports will support different protocols: Port/Protocolġ0/100Mb Ethernet, PoE+ (Power over Internet) 802.3af/at Supported Serial topology A serial camera connected to CI0 .

CY-CI03P: A third ports available for cam head management.

Port Pinout ĭifferent CI0 models differentiates on number and type of ports: The Integration manuals also provide information on what cable to use for what camera. Serial ports connector refererence: Hirose HR10A-7R-6S(73)Ĭyanview provides a range of cables to interface most cameras. Specific guidance for supported cameras and devices configuration can be found in the Integration section.

This page covers the generic CI0 characteristics and configurations.

Blackmagic rs422 serial port